1.  |
2.  |
transom in
need of repair |
access from top, drain
tubes and tow hooks removed |
3.  |
4.  |
drill holes in prep for
chainsaw method |
remove wood with chainsaw,
carefully! |
5.  |
6.  |
make sure all wood is removed |
place spacer and bolts,
secure transom skins |
7.  |
8.  |
tape holes & cracks,
place waxed pvc in drain holes |
place trough funnel and
secure it |
9.  |
10.  |
2 buckets of Seacast |
open bucket & mix completely,
then add catalyst |
11.  |
12.  |
add ground fibers |
mix fibers well |
13.  |
14.  |
pour in trough, side-to-side
motion |
tap with rubber mallot
to release any air bubbles |
15.  |
16.  |
fill transom to top |
lay fiberglass cap on top
of transom |
17.  |
18.  |
tuck in fiberglass cap |
next place a funnel to
pour into wings of transom |
19.  |
20.  |
use a wood dowel to spread
Seacast in wing |
use waxed wood slats to
hold Seacast in wings |
21.  |
22.  |
remove cap and start sanding |
tape off for paintiog,
Voila! |
